![configure a cisco asa 5505 firewall configure a cisco asa 5505 firewall](https://i1.wp.com/www.gns3network.com/wp-content/uploads/2020/02/How-to-configure-IPSec-VPN-between-Palo-Alto-and-Cisco-ASA-FIrewall-e1580545453196.png)
When you are finished the ACL Manager should now resemble the image from step 1. If your ACL Manager does not show the access rules for the H323-Group, as shown in the image below, proceed to step ) In the center window, right click the Inside_Access_In ACL, and then Add ACE 3) In the window that appears, ensure the following parameters are configured: Action: Permit Source: Any Destination: Any Service: H323-Group Once the ACE is configured with the above parameters, shown below, click OK.ġ0 4) In the center window, right click the Outside_Access_In ACL, and then Add ACE 5) Configure the ACE with the same parameters from step 3. In most cases the ASA will automatically create the appropriate ACL entries during the while completing the previous sections of this guide. Then expand the Advanced menu by clicking the + icon next to Advanced, and then click ACL Manager. Congratulations, you have successfully configured your Access Rules!ĩ Confirm the ACL Manager 1) From the ASDM configuration tool, click on Configuration, Firewall. 8 The finished rule should resemble the following: 5) In order to create the Access Rule which will allow traffic to traverse the firewall from External to Internal, repeat the steps above, but ensure the Interface: is set to Outside as shown below.